Previous Topic

Next Topic

Book Contents

Book Index

Saving Settings as Default and Restoring Original Settings (v9 - Feature 42)

Previously, the Sizer program settings were saved as default for new files via the Save as default menu item under the Settings menu. When selected, all the program settings that appear in various tabs of the Settings dialog, and many of the options that appear in Beam View, Column View, and Loads View, would all be saved at once to the initialization file, where they would be used the next time a new file was opened.

Similarly, to restore the settings that are shipped with new installations of Sizer, you selected the Restore ‘factory’ menu item, and all settings and these other options would be reset to their default value.

This system has been overhauled so that it now operates as the Shearwalls program does – a checkbox called Save as default for new files and a button called Reset original settings appears in each of the settings tabs, and in Load Input view for both Beam and Column mode. When the checkbox is checked or the button is pushed, the action applies only to the settings or options that appear on the screen, not to all settings and options.

Settings Menu

The sub-items Save as default and Restore ‘factory’ have been removed from the menu. Pushing the Settings menu now goes directly to the settings input dialog. The lengthy messages that used to appear explaining the location of all the items that are restored or saved are no longer necessary and have been removed.

Save as Default

A checkbox called “Save as Default for new files” has been added. It defaults to being disabled and checked if no files are open, as in that case the settings can only be used to create defaults for new files. It defaults to being unchecked if files are open, as in that case you may be adjusting the setting for the current file and not want it to persist for new files that are created later.

Reset Original Settings

A button Reset Original Settings has been added to all the settings except for

Beam View Options

When the Default settings are saved or restored, they also save or restore the Span type and For unknown bearing length options that show in Beam View rather than in the Default settings. A note in the default settings indicates this

Load View Options

Buttons called Save as default options and Reset original options have been added to beam and column Load Input view to save and restore the options shown on the right had side of that view. The only options not saved are those shown are the ones which add a moving concentrated load, enter point load as UDL, and combine loads of same type in drawing. A message box appears when pressing one of these buttons explaining which options are saved or restored.

Additional Settings Now Saved as Default

The number of settings and options it is possible to save as default has been expanded to include the following:

Beam supports area loads from continuous joists

Importance category

Live and snow loads on exterior

Sustained live load type

See Also

Program Operation

User Defined Logo (v9 - Feature 87)

Elimination of Text Output Files (v8.41 - Feature 168)

Column Load View Pop-up Window (v8.41 - Bug 2381)

Default Loads View in Pop-up Window Setting (v9 - Change 177)

Persistence of Project Setting Information (v9 - Bug 2752)

Apply to Concept Mode Message (v9 - Change 130)

Default Open File Setting (v9 - Change 146)

Design Settings Moved to Default Settings Page (v9 - Change 155)

Asterisk in Design Settings (v9 - Change 155)