Previous Topic

Next Topic

Book Contents

Book Index

KD Factor Table in Analysis Output (Bug 2136)

The KD factor table in the Analysis Output sometimes reported a single KD value when it instead should say "See table below” and output a table of differing KD values for each span and design criterion.

It reported the full table when CSA 4.2.3.2 for high permanent loads was invoked, but there are other reasons that KD's can be different on different spans and for different design criteria, particularly pattern loads. In those cases the full table was not output, and a result, KD for a particular combo could be different than the single value that was output in the design report. This has been corrected.

See Also

Output Reports

Print Banner in Design Check (Change 89)

Actual/Nominal Size in Materials Specification (Feature 66)

Multi-ply Width in Materials Specification (Feature 90)

Column Lateral Reactions (Change 60)

Self-weight Note and Self-weight in Loads Table (Change 80)

Effect of Point Loads on Vertical Reactions in Analysis Table (Change 38)

Interior Spans Cantilever Deflection Reporting (Bug 2320)

Modification Factors for I-joists (Bug 2218)

Vertical Reaction Table for Concentrated Load (Bug 2141)

Concentrated Beam Load Width Units (Bug 2240)

SCL System Factor KH Reporting (Bug 2043)

Units for f/E Values in Modification Factors Table (Change 90)

Additional Data Note for Live Deflection (Change 33)

Spelling, Formatting, and Nomenclature Changes (Change 99)