|
|
|
|
|
Shear Capacity Results when there are Non-shearwalls (Bug CSW7-9)
When a shearline consists of one shearwall and at least one non-shearwall, the Shear Results table the output was not showing the capacity information Vhd/L, Jhd and V, for that line.
Fastener Spacing Unit Label (Bug 1664)
The units beside the input for fastener “Inter. Spacing" (field spacing) were displayed as mm, when the values in the list were in inches.
Fastener Penetration Units (Bug 1773)
The fastener penetration information in the Materials by Wall Group table was always displayed in millimetres even though it should display in inches when Imperial units are selected.
75mm Edge Nail Spacing (Bug CSW7-37)
The program was reporting 75mm edge nail spacing as 70mm. The design calculations were using 75mm.
Fastener Information in Elevation View (Bug 1572)
Imperial units fastener information in Elevation View showed metric nail thickness without displaying mm, incorrectly showed metric edge spacing, and showed a fractional value for field spacing that was slightly different than the round number input into program.
Imperial Capacities in Elevation View (Bug CSW7-24)
Nonsensical values were showing for elevation view for shear capacity and C&C capacity in the elevation view material specification, due to unit conversion problems.
Shear Capacities for Zero-length Segments (Bug CSW7-30b )
When shear capacities differ for different segments, the program was outputting results for zero-length segments, causing repetition.
Header on Printed Design Results (Bug 1167 )
The header information and page numbers were present only on the first page of the design results printout.
Maximum Font Size for Page Width (Bug 1330 )
The printed text output in 10 size font did not completely fit onto the width on regular letter-size page. It now prints fits with 11 size font.
Wind Uplift and Dead Loads Table Headers (Bug 1775)
The headers for wind uplift loads and dead loads were the same as the ones for building masses, when they should have headings appropriate to these loads. As a result, the Profile column was misaligned.
Incomplete Design Material Specification
For large, complicated structures with openings and non-shearwalls, for some shearlines the Materials table contained "?" for nail spacing or sheathing thickness.