Previous Topic

Next Topic

Book Contents

Book Index

Negative Jhd Factor for Hold-downs on All Walls (Bug 2445)

For a particular project, two walls on one level were not designed, so that the program showed vertical elements rather than wall ends at the hold-down locations, the hold-downs were not designed, and a spurious message regarding a negative Jhd appeared. Upon examination, this problem was caused by incorrect conversion of joist spacing when toggling between metric and imperial modes. This has been corrected.

See Also

Engineering Design

Crash on Design with Non-shearwalls (Bug 2395 – Version 8.1)

Wall Height at Gable Ends for Hold-down Force Calculation (Bug 2465)

Creation of Wall Groups due to Hold-down Data (Bug 2323)

Inclusion of Gypsum Capacity for Tall Walls (Bug 2447)

Extraneous Message when Running a Design (Bug 2439)

Irregularity Check Warning (Change 110 – Version 8.1)