Previous Topic

Next Topic

Book Contents

Book Index

Hold-down Settings Dimensional Units ( Bug 2468)

Retention of Precision

The values input into the Hold-down Settings box could lose precision when updating after the following operations

These problems have been corrected, and in general values appear to 1/10 of a millimetre and 1/1000 of an inch, however the program will show even millimetre amounts without the decimal, and will remove all but one trailing zero after the decimal place for inches. If more precise values are entered, they will be retained internally, but will be replaced by the rounded value if view is re-entered and another value is modified.

Bolt Hole Tolerance

In metric units, the default bolt hole tolerance would sometimes appear as 0.0625 mm, that is 1/16th of a millimetre. It is meant to be the metric equivalent of 1/16” . This has been corrected.

See Also

Data Input and Program Operation

Standard Walls

Stud Width and Thickness

Legend Checkbox in Options Settings (Bug 2398– Version 8.1)

Spin Controls for Building Levels in Generate Loads Input View (Bug 2387 - Version 8.1)

Deflection Analysis Setting Update (Bug 2327)

Version Number in Program Name (Change 111)

Streamline Network Version Setup (Design Office Feature 8)