Previous Topic

Next Topic

Book Contents

Book Index

Sizer 10.41 – October 8, 2015 - Design Office 10, Service Release 4a

This was released to only a limited number of users as the bulk of users were not informed that is was available until service release 4b had already been made.

  1. Column Supporting Member Bearing Design Units (Bug 3090)
  2. The units for supporting member bearing design in the Analysis vs. Design table are showing as kips, but the values are actually in psi. This has been corrected
  3. Self-weight of Built-up Columns for Supporting Member Bearing Design (Bug 3089)

    For built-up columns, the self-weight used for the supporting member bearing design was the self-weight of one ply multiplied by the number of plies twice, resulting in an axial load that was too large by the self-weight of the member. This has been corrected.

See Also

Sizer 10

Design Codes and Standards

Fire Design

Other Engineering Design

Loads and Loads Analysis

Materials Database

Concept Mode Operation

Input and Output

Sizer 10.1 – January 14, 2013 – Design Office 10, Service Release 2

Sizer 10.2 – Sept 23, 2014 – Design Office 10, Service Release 3

Sizer 10.4 – August 20, 2015 – Design Office 10, Service Release 4

Sizer 10.42 - October 25, 2015 - Design Office 10, Service Release 4b