Previous Topic

Next Topic

Book Contents

Book Index

Component and Cladding Tables Design Tables (Bug 2885)

The following corrections have been made to the Components and Cladding design tables that show out-of-plane sheathing and nail withdrawal design:

Interior Walls on Same Line as Exterior Walls

When a shearline goes from the interior to the exterior of the structure, the program output a line of design results for walls that are on the interior of the structure and are not loaded. Those lines would show zero nail withdrawal force but non-zero sheathing force. These lines have been removed.

Duplicate Entries for the Same Wall Group

The program output a line of data for each shearwall in a line, however showed results by wall group rather than by individual walls. Therefore there were duplicate lines when more than one wall on a line had the same wall design group. This has been corrected and the program shows only one line for each design group on a shearline

See Also

Panel Marking in Sheathing Materials Output (Bug 2808)

Shear Results Output for Shearlines which Extend over Part of Structure (Bug 2822)

Cumulative Storey Shear in Seismic info Table (Change 137)

Shearwall Wall and Opening Dimensions Table Legend (Change 162)

Output of Bx for Torsional Irregularity (Change 154)

Design Code Clause in Irregularities Table (Change 152)

Default Design Results View (Change 155)

Code reference for Gust Effect Factors in Log File (Change 166)

Blank Page in Output (Change 157)

Log File for Torsional Analysis Changes (Changes 138-141)

Capitalization of Load Case (Changs.142)

Version 9.3