Previous Topic

Next Topic

Book Contents

Book Index

Serviceability Importance Factor in Load View Input (v8.4- Change 127)

In the input for Importance factor in Load View, we now indicate the serviceability load factor as well as the one for ultimate limit states. This is particularly important for snow loads, because designers are allowed to use Part 9 snow loads which do not include a serviceability factor. In this case, the input selection indicates that Sizer then factors these loads by 0.9, so the designer can make the necessary adjustment to the load magnitude to compensate.

See Also

Lateral Support Changes

Reaction in Analysis Diagram on Right Support with Left Cantilever (v8.4- Bug 2691)

Partial Line Loads on Beams in Concept Mode (v8.4- Bug 2673)

Uplift Reactions at Base (v8.4- Bug 2672)

Formatting of Support Bearing Results for Columns (v8.4- Change 128)

Asterisk for Beam and Stringer Grades Setting (v8.4- Change 144)

I-Joist Input in Database Editor

Link to Custom Version Web Page (Change v8.4- 137)

Transfer of Partly Uplift and Partly Gravity Reactions from Joist Area to Supporting Member (v8.32 - Bug 2660)

Transfer of Loads from Column Close to Intersection of Beams (v8.32 - Bug 2661)

Concept Mode Crash For Triangular Joist Area With No Dead Loads (v8.32 - Bug 2659)