Concept Mode Crash For Triangular Joist Area With No Dead Loads (v8.32

Concept Mode Crash For Triangular Joist Area With No Dead Loads (v8.32 - Bug 2659)

Triangular joist areas in concept mode without any dead loads, and for which self-weight is set to Manual input , were causing Sizer to crash when designing or exporting a member that is below the triangular joist area in the building.

See Also

Lateral Support Changes

Reaction in Analysis Diagram on Right Support with Left Cantilever (v8.4- Bug 2691)

Partial Line Loads on Beams in Concept Mode (v8.4- Bug 2673)

Uplift Reactions at Base (v8.4- Bug 2672)

Serviceability Importance Factor in Load View Input (v8.4- Change 127)

Formatting of Support Bearing Results for Columns (v8.4- Change 128)

Asterisk for Beam and Stringer Grades Setting (v8.4- Change 144)

I-Joist Input in Database Editor

Link to Custom Version Web Page (Change v8.4- 137)

Transfer of Partly Uplift and Partly Gravity Reactions from Joist Area to Supporting Member (v8.32 - Bug 2660)

Transfer of Loads from Column Close to Intersection of Beams (v8.32 - Bug 2661)