Previous Topic

Next Topic

Book Contents

Book Index

I-Joist Input in Database Editor

The following problems pertaining to the modification of I-joist material properties in Database Editor have been corrected. They are listed here because I-Joists are used only by the Sizer program.

Fc for I-Joists (v8.4- Change 134)

Database editor showed a value of zero for axial compression Fc for I-joists, which Is not relevant to I-joist design. It no longer appears in Database Editor.

Fc for I-Joists (v8.4- Change 135)

Starting with version 8.1, Database Editor always shows a value of zero for shear constant K for I-joists. This has been corrected, and the value from the database is now shown.

See Also

Lateral Support Changes

Reaction in Analysis Diagram on Right Support with Left Cantilever (v8.4- Bug 2691)

Partial Line Loads on Beams in Concept Mode (v8.4- Bug 2673)

Uplift Reactions at Base (v8.4- Bug 2672)

Serviceability Importance Factor in Load View Input (v8.4- Change 127)

Formatting of Support Bearing Results for Columns (v8.4- Change 128)

Asterisk for Beam and Stringer Grades Setting (v8.4- Change 144)

Link to Custom Version Web Page (Change v8.4- 137)

Transfer of Partly Uplift and Partly Gravity Reactions from Joist Area to Supporting Member (v8.32 - Bug 2660)

Transfer of Loads from Column Close to Intersection of Beams (v8.32 - Bug 2661)

Concept Mode Crash For Triangular Joist Area With No Dead Loads (v8.32 - Bug 2659)